颗粒烘干机-塑胶干燥机

DDS大型除湿干燥机系统应用於塑胶使用大且露点要求低的场合。本公司制造的大型除湿干燥系统用於处理PET原料时zui高可达800kg/h。该系统主要包含每小时干燥风量zui高4.000m3的蜂巢转轮式除湿机及容料量高达8.000L（於装载PET时的有效重量为6.400kg）的保温式干燥料桶，经由转轮除湿机处理过后的干燥原料zui终含水率zui高可以达到0.004%以下。

Large dehumidifying drying system

When you need to use large quantity of plastic and lower dew-point, you should choose DDS series large dehumidifying drying systems.

DDS series' capacity can reach 8000kg/h. This system includes honeycomb rotor dehumidier（8000m3/h） and insulation hopper

（10000L or 8000kg PET）. After treatment, the highest rate of dry raw material can reach the nal moisture content below 0.004%.

本机特点：

1. 定速搅拌设计使未结晶之塑料在晶相化的制程温度中不沾结成块；

2. 结晶效率高且均匀；

3. 可以简化并提高原料干燥时的效率；

4. 原料干燥可以在高温下进行 , 并且干燥过程可以直接使用现有的标准干燥料桶；

5. 制程温度可透过温控器进行准确控制；

6. 增加回收料在 PET 新料中的使用比例；

7. 可搭配除湿机 , 直接执行除湿作业；

8. 可选配螺旋送料装置定量输出已结晶原料。

Proudcts Features

1. Constant speed stirring uncrystallized designed so that the plastic does not stick 

in the temperature of the crystalline phase of the process to form blocks；

2. Crystallization eciency is high and uniform；

3. It can simplify and improve the eciency of the raw material drying process；

4. Drying of the raw material can be performed at high temperature, and the drying 

process can be used directly to the existing standard drying drum；

5. Process temperature can be accuray controlled by thermostat；

6. Increase the proportion of recycled material in the use of new PET material；

7. it is optional of the dehumidier that can directly perform the dehumidication work.；

8. Optional screw feeding device output the crystallized material quantitatively.

规格表  Specifications 

产品规格若有变更，恕不另行通知

The specification is subject to change without prior notice.

 ☆机器电压规格为 :3￠,400V,50Hz.